Filter
Top Products
4-60
435/485/535
F4-93
Operation 83
Change the Ether Canister
The cold start solenoid is mounted on the left side of
rear hood support.
Remove the protective yellow cap (1) or unscrew the
empty ether canister anti-clockwise from the top of
the solenoid valve (2), making sure that the gasket
remains in place. Lubricate the gasket with a light film
of clean oil.
Remove the protective cap from the new ether
canister.
Lower the ether canister (3) into the top of the solenoid
valve (2) and screw it in clockwise.
Tighten the ether canister hand tight only.
Once the ether canister is screwed into the solenoid
valve, secure the canister firmly by attaching the
clamp (4) around the canister. Tighten the clamp.
NOTE: The ether bottle is not shipped as standard
equipment from the factory and should be sourced
locally.
CAUTION: STARTING FLUID IS HIGHLY
FLAMMABLE. DO NOT USE NEAR FIRE, SPARKS,
OR FLAMES. BE SURE ALL OPERATORS READ THE
CAUTIONARY INFORMATION ON THE CANISTER.
CAUTION: THE ETHYL ETHER USED AS COLD
START FLUID IS EXTREMELY FLAMMABLE, TOXIC,
AND FATAL IF SWALLOWED. AVOID CONTACT WITH
EYES OR SKIN. AVOID BREATHING THE FUMES.
IF SWALLOWED, DO NOT INDUCE VOMITING. CALL
DOCTOR IMMEDIATELY.
IF COLD START FLUID ENTERS EYES OR FUMES
IRRITATE EYES, WASH EYES WITH LARGE
QUANTITIES OF CLEAN WATER FOR 15 MINUTES.
CONTACT A DOCTOR, PREFERABLY AN EYE
SPECIALIST, IMMEDIATELY.
1
F4-94
2
2
3
4
Section 4 - Lubrication & Maintenance
As Required