Filter
Top Products
4-18
435/485/535
Section 4 - Lubrication & Maintenance
Every 10 Hours or daily
F4-13
1
F4-14
2
Operation 18
Air Intake Piping / Charge Air piping
Inspect the air intake piping, daily, for cracked hoses,
loose clamps, or punctures that could damage the
engine with particular attention to the two connections
(1&2) between the air cleaner and turbocharger.
Tighten or replace parts, as necessary, to make sure
the air intake system does not leak.
Torque Value: 8.5 N·m (75 in-lbs)
Check for corrosion of the intake system piping
under the clamps and hoses. Corrosion can allow
corrosive products and dirt to enter the intake system.
Disassemble and clean as required.
Inspect the two charge air pipes (3) and four connection
hoses (4) for cracks, loose clamps, or punctures that
could damage the engine.
Tighten or replace parts, as necessary, to make sure
the charge air system does not leak.
Torque Value: 7.35 N·m (65 in-lbs)
F4-98
3
4