Filter
Top Products
Assembly
Your generator requires some assembly and is readyfor use
after it has been properly servicedwith the recommended
fuel and oil.
If you haveany problemswith the assemblyof your generator,
pleasecall the generator helplineat (800} 743-4115. If calling
for assistance,pleasehavethe model, revision,and serial
number from the identificationlabel available.SeeGenerator
Controls andFeaturesfor identification labellocation.
UnpackGenerator
1. Setthe carton on a rigid, flat surface.
2. Remove everything from carton exceptgenerator.
3. Opencarton completely by cutting each corner from
top to bottom.
4. Leave generator on carton to install wheel kit.
The generatoris suppliedwith:
• Operator's manual
• Batteryfloat charger
• Oil bottle
• Wheel kit
Install Wheel Kit
NOTE:Wheel kit is not intended for over-the-road use.
You will needthe following tools to install these
components:
• 7/16" and 13 mm wrenches
• Socket wrench with 7/16" and 13 mm sockets
• Pliers
• Safety glasses
Install the wheel kit as follows:
1. Tip generatorso that engine end is up.
2. Slide axle (A) through both mounting brackets.
3. Placea wheel (B) on each side as shown below.
4. Place a washer (C) on axle and then placean e-ring (D)
in axle groove.
_i, CAUTION E-rings can causeeye injury.
E-rings can spring back and becomeairborne
when installing or removing.
• Alwaysweareyeprotectionwheninstalling/removinge-rings.
5. Install e-ring with pliers, squeezingfrom top of e-ring
to bottom of axle.
6. Repeatsteps 4 and 5 to secure second wheel.
7. Tip generatorso that engine side is down.
8. Attachthevibration mounts (E) to the support leg (F)
with 1/4-20 x 1" capscrews (G) and 1/4-20 lock nuts (H).
9. Removeexisting Iocknut from left unit vibration mount
with 13mm wrench. Use same Iocknut to attach
support leg.
10. Attach other side of support leg with a M8 x 20 mm
capscrew (J) and M8 lock nut (K).
11. Return generator to normal operating position (resting
on wheels and support leg).
/