Briggs & Stratton Portable Generator Portable Generator User Manual


 
_i, WARNING Contact with muffler area can result in
serious burns.
Exhaust heat/gases can ignite
combustibles, structures or damage
fuel tank causing a fire.
DO NOTtouch hot parts and AVOID hot exhaust gases.
Allow equipment to cool before touching.
Keepat least5 feet (152 cm) of clearanceon all sides of
generator including overhead.
It is a violation of California Public Resource Code,Section
4442, to use or operate the engineon anyforest-covered,
brush-covered, or grass-covered land unlessthe exhaust
system is equipped with a spark arrester, as defined in Section
4442, maintained in effective working order. Other states or
federal jurisdictions may have similar laws.
Contact the original equipment manufacturer, retailer, or dealer
to obtain a sparkarrester designed for the exhaust system
installed on this engine.
Replacement parts must bethe same and installed in the same
position as the original parts.
_i, WARNING Unintentional sparking can result in fire or
_ electric shock.
WHENADJUSTINGOR MAKINGREPAIRSTO YOURGENERATOR
Disconnect the spark plug wire from the spark plug and place
the wire where it cannot contact spark plug.
WHENTESTINGFORENGINESPARK
Use approved spark plug tester.
DO NOTcheckfor spark with spark plug removed.
_i, WARNING Starter and other rotating parts can
entangle hands, hair, clothing, or accessories.
NEVERoperate generator without protective housing or covers.
DO NOTwear looseclothing, jewelry or anything that may be
caught in the starter or other rotating parts.
Tie up long hair and remove jewelry.
_i, CAUTION Excessively high operating speeds increase
risk of injury and damage to generator.
Excessively low speeds impose a heavy load.
DO NOTtamper with governed speed. Generatorsupplies
correct rated frequency and voltage when running at governed
speed.
DO NOTmodify generator in any way.
NOTICE Exceeding generators wattage/amperage capacity
can damage generator and/or electrical devices connected to
it.
DO NOTexceedthe generator's wattage/amperage capacity. See
Don't OverloadGeneratorin the Operationsection.
Start generator and let engine stabilize before connecting
electrical loads.
Connectelectrical loads in OFFposition, then turn ONfor
operation.
Turn electrical loads OFFand disconnect from generator before
stopping generator.
NOTICE Improper treatment of generator can damage it
and shorten its life.
Use generator only for intendeduses.
If you havequestions about intended use,ask dealeror contact
local service center.
Operategenerator only on level surfaces.
DO NOTexposegenerator to excessivemoisture, dust, dirt, or
corrosive vapors.
DO NOTinsert any objects through cooling slots.
If connected devicesoverheat, turn them off and disconnect them
from generator.
Shut off generator if:
-electrical output is lost;
-equipment sparks, smokes, or emits flames;
-unit vibrates excessively.
6 BRIGGSandSTRATTON.COIVI