5
ASSEMBLYPROCEDURES
Grasscatcher
Assembling the Grasscatcher
1 Assemble the adjustable covers 1A or directional covers 1B to the top half of the
grasscatcher (If applicable to your model). Check that all of the snap hooks have engaged
securely.
2 Locate the centre protrusion of the mesh into the centre hole on the inside of the catcher top,
ensuring the curved edge of the mesh faces the rear handle. Firmly push the mesh into the
top half of the catcher, making sure that the four snap hooks engage securely.
3 Loosely locate the rear handle areas of the top and bottom catcher halves then loosely locate
the side edges. Check that all eight hooks from the top half are loosely located in the slots
on the bottom half then firmly push the two halves together over each snap hook. Check that
all of the snap hooks have engaged securely.
4 Tighten the two screws fitted to the front of the catcher.
Assembly_Operating K6 final.qxd 8/12/04 1:33 PM Page 8