Remote Air Filter Maintenance – Aerogrip handles
1. Examine the air filter hosing for holes, chafing and leaks. Replace it if damaged.
2. Remove the top cover of the air filter housing by squeezing the latch on the underside of the
housing and lifting upwards.
3. Remove the element and the foam seal ring, taking care that any loose dirt does not fall into
the filter body.
4. Dust off the seal and examine it. Replace it if damaged or permanently crushed. Refit seal to
housing.
5. Clean the element by slapping it on the palm of your hand. Do not use compressed air or
wash the element in any liquid. Examine the element for holes, splits or permanent clogging.
Replace the element if necessary. Refit element to housing.
6. Refit the top cover by making sure the lugs at the rear of the cover are located before clipping
in the latch.
Seal ring
Lugs
Element
Latch
Unclip here to
remove top
14
Assembly_Operating K6 final.qxd 8/12/04 1:33 PM Page 17