Filter
Top Products
8
ASSEMBLYPROCEDURES
PIVOT JOINT COMPONENTS
ITEMS QTY
1. Upper Handle x 1
2. Centre knuckle x 1
3. Inner mating pieces x 2
4. Outer mating pieces x 2
5. Fastening knobs x 2
(incl. bolt)
6. Lower handles x 2
Aerogrip Handle Assembly
66
44
55
2
33
11
Your Aerogrip handle may require some
assembly before its first use. If the upper
and lower handle have been supplied
unattached, follow these instructions below.
Assembly Procedure
Fig 1. Fig 2.
1. Unscrew fastening knobs and outer mating pieces from each side of pivot joint assembly.
2. Lay the upper handle across the engine cowl of the lawnmower, with the bend facing
down (see fig 1).
3. Position the ends of the upper handle over the lower handles at the pivot joint, so that the
holes are all aligned.
4. Replace the outer mating pieces on each side and partly tighten into place with fastening
knobs, but do not fully tighten yet (see fig 2).
5. The Aerogrip handle may now be lifted into its normal operating position, and the fastening
knobs fully tightened.
Assembly_Operating K6 final.qxd 8/12/04 1:33 PM Page 11