Filter
Top Products
For correct engine performance and to guard against dust entering the engine, causing
rapid wear, the air filter assembly must be clean and maintained in good condition. VICTA
recommends that the air filter element and seal ring are replaced annually, or more often in
dusty conditions. Always replace with genuine Victa spare parts. Use of non-genuine spare
parts may damage your mower engine, and void the product warranty.
Remote Air Filter Maintenance
STOP ENGINE.
(Fig. 1) 4 stroke models, twist filter cap anti-
clockwise and remove cap from filter
housing.
(Fig. 2) 2 stroke models, lever cap off using
screw driver in slot in side of filter body.
To stop loose material falling into filter body,
tilt upper handle so that filter body is up-side
down. Remove filter element and seal ring.
(Fig. 3) Clean filter element “A” by tapping it
on palm of hand. Do not use compressed air
or wash with any liquid. Examine element for
holes, splits or permanent clogging. Replace
if necessary.
Dust-off seal ring “B” and examine. Replace
if damaged or permanently crushed.
(Fig. 4) Fit or refit seal ring and filter element.
Tilt upper handle back to normal position.
Push filter cap on, ensuring teeth engage in
slots on filter housing.
Victa Air filter for all 2 stroke & 4 stroke
domestic models Part No AF072825
Replacing Air Filters
13
Fig. 2Fig. 1
Fig. 3
A
B
Fig. 4
Assembly_Operating K6 final.qxd 8/12/04 1:33 PM Page 16