Filter
Top Products
12
Text
Blade Replacement (All Models)
Model Blade & Bolt Set
All 19” Steel & Alloy Chassis Models CA094705
For Your Safety
• Never use the mower unless the grasscatcher or the guards supplied by the
manufacturer are in position.
• Before starting the mower check blades and bolts for damage or wear.
• If you strike an obstruction, stop the engine and check the blades for damage.
Worn and damaged blades are major hazards.
• Stop the engine and disconnect the spark plug lead before fitting new blades.
•Work from the catcher flap.
With the rear flap secured,
undo the blade nut, applying
upward pressure to the bolt
head into the blade disc. (the
head of the bolt will not rotate
due to the diamond shape in
the underside of the head).
Assembly: Fit as per the
drawing remembering to push
the head of the bolt into the
blade disc. (this will stop the
bolt head from turning).
Ensure correct order of
assembly.
DO NOT
lay mower on side (4 stroke models).
•We recommend changing blades, bolts, nuts and washers as a set. Metal fatigue and
damage may occur which may not be visible to the operator. Always replace all blades to
ensure correct engine balance, reducing vibration and wear. Tighten nuts on blade bolts
to 14-19 Nm (Newton Metres) or 10-14ft lbs.
• Always turn the nut to check tightness, not the bolt.
Use only genuine replacement parts made and guaranteed by Victa.
Insist on them from your parts and service dealer.
Detailed fitting instructions are printed on genuine Victa blade packs.
Use of non-genuine blades may void your warranty, and could result in
damage or injury.
Assembly_Operating K6 final.qxd 8/12/04 1:33 PM Page 15