Filter
Top Products
ASSEMBLYPROCEDURES
Nut
Screw
Air filter
housing
Nut
Screw
Throttle
Control
Aerogrip
handle
2 Stroke Models
Slide the air filter housing onto the upper handle. Position locating lug
into hole in handle and secure with screw (see Fig.3). Be careful not
to over tighten, as the plastic thread may be damaged.
1. Firstly secure the throttle control to the right
hand side of handle, on the outside
(see Fig. 4) using the 50mm screw and
nut pictured here.
2. For models supplied with r
emote air filter. After
attaching the throttle control, secure the air filter
housing to the right hand side of handle, on the
inside (also fig 4), using the 38mm screw
& nut pictured here.
4 Stroke Models
Aerogrip
handle
Air filter
housing
25mm
(Actual size)
Screw
(Please Note:
Do not over
tighten)
2 Stroke Models
4 Stroke Models
Attaching The Remote Air Filter Housing – Aerogrip Handles
50mm (Actual size)
38mm (Actual size)
Fig 3. Fig 4.
9
Assembly_Operating K6 final.qxd 8/12/04 1:33 PM Page 12