Filter
Top Products
GB - 23
NOTE: Insert the hair pin with the loop end on the left
side of the chute rod so the control lever will cover its
full range of travel.
6. Align correct chute rod holes in chute control
assembly as shown in Figure 25, and then secure
chute rod in position with hair pin remove in
step 1.
7. Check and adjust attachment clutch, speed
selector and traction clutch. See Speed Selector
Adjustment on page 24 and Traction Drive Clutch
Adjustment on page 27.
8. Re-install bottom cover.
DEFLECTOR REMOTE
Deflector must stay in selected position while throwing
snow.
If deflector does not stay in set position:
1. Tighten nut beneath control panel to increase
pressure on deflector control (Figure 26).
If deflector does not follow full range of travel:
1. Push deflector remote all the way forward.
2. Loosen adjusting nuts on cable support bracket
underneath the dash panel (Figure 26).
3. To adjust the deflector lower:
Slide cable down. Tighten bottom nut.
4. To adjust deflector higher:
Slide cable up. Tighten top nut.
5. Check travel and repeat adjustment as
necessary.
DISCHARGE CHUTE
If chute does not stay in position while throwing snow
or if chute does not rotate freely, adjust the cable under
the control panel so the chute lock fingers engage or
disengage the locking gear.
If chute does not stay in position:
Loosen the cable by loosening the lower adjustment
nut, and then tightening the upper adjustment nut
against the bracket (Figure 27).
Figure 24
1. Upper Position
2. Lower Position
3. Handlebar
4.Upper Mounting Bolt
5.Lower Mounting Bolt
1
2
3
4
3
5
5
4
1
2
OS7155
Figure 25
1.Chute Control Assembly
2. Hair Pin
3. Chute Rod
2
1
1
2
3
3
Upper Position Lower Position
OS7160
Figure 26
Tighten nut.
2
1
1.Adjusting Nuts
2.Cable Support Bracket
OS7175