Filter
Top Products
GB - 15
Discharge Chute Control
IMPORTANT: If chute does not stay in set position,
adjust as directed in SERVICE AND ADJUSTMENTS
on page 22, or repair before operation.
Rotate the Chute with Discharge Chute Control.
IMPORTANT: DO NOT force frozen chute controls. If
frozen, take to warm place until controls are free.
Heated Handles
Turn the heated handles switch to the
ON (1) position to activate. Turn the
switch to the OFF (2) position to
deactivate.
Differential Lock (926021, 022, 023)
(Figure 14)
The differential can be locked for maximum traction or
unlocked to allow for easier turning. The differential
lock knob is located on the right Track Assembly. With
the differential locked power is applied equally to both
tracks.
To engage the differential lock:
Pull and turn knob to LOCKED (1) position and release
(knob will snap in place when positioned correctly).
To release the differential lock:
Pull and turn knob to the UNLOCKED (2) position and
release (knob will be positioned out slightly from unit
when positioned correctly).
Scraper Blade
The scraper blade allows the back of the housing to
keep better contact with the surface being cleared. It
also prevents damage to the housing from normal
wear.
IMPORTANT: DO NOT allow Scraper Blade to wear
too far or Auger/Impeller housing will become
damaged.
Runners
The runners control the distance between the scraper
blade and the ground. Adjust runners equally to keep
blade level with the ground. Refer to Pre-Start on
page 17 for recommended settings.
Figure 13
OS7105
OS1950
1
2
Figure 14
Differential
Lock Knob
1
2