Filter
Top Products
GB - 16
Drift Cutters
(Figure 15)
Drift cutters break up snow drifts that are taller than the
auger housing and direct the snow into the auger. Store
the drift cutters on the auger housing when not in use.
Install them as shown below so they are taller than the
snow to be cleared.
Track Angle (926021, 022, 023)
(Figure 16)
The track angle can be adjusted to position the auger
housing for level clearing, deep cutting or transport.
Depress the Foot Pedal and press down on the
handlebars to move the auger housing into an up
position.
Lift up on the handlebars and tap the Foot Pedal to
move the auger housing into a down position.
FILLING FUEL TANK
Fuel Shut-Off Valve
IMPORTANT: The fuel shut-off valve MUST be in the
closed position prior to transporting the unit.
The fuel shut-off valve has two positions:
Figure 15
1.Stored Position
2. Operating Position
1
2
OS7110
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
Figure 16
Deep Cutting
OS7111
Transport
Normal
Foot Pedal
Foot Pedal
Foot Pedal
Figure 17
Open Position: Use
this position to run
the unit.
Closed Position:
Use this position
to service,
transport, or store
the unit.
926016, 017, 500, 501
OS7117