Ariens 926314-ST9526DLET Snow Blower User Manual


 
GB - 28
7. Check and adjust attachment clutch,
speed selector and traction clutch. See
Speed Selector Adjustment on page 29
and Traction Drive Clutch Adjustment on
page 32.
8. Re-install bottom cover.
REMOTE WHEEL LOCK (926302)
If remote wheel lock does not lock or unlock:
1. Place unit in service position (see
Service Position on page 23).
2. Loosen jam nuts on cable. Make sure
the bottom jam nut is loosened enough
to remove slack from cable (Figure 27).
3. Pull the cable adjuster to remove slack
between the cable adjuster and the
extension spring and hold the cable
adjuster in position while finger
tightening the top jam nut against the
bracket. Do not extend the spring or
engage the mechanism.
4. Tighten the bottom jam nut.
5. Check function of remote wheel lock. If
wheel lock does not function properly,
remove bottom cover to check cable
slack.
6. Repeat steps 2 – 4 while watching cable
to remove slack.
7. Check function of remote wheel lock. If
wheel lock does not function properly,
take the unit to Dealer for repairs.
DEFLECTOR REMOTE
Deflector must stay in selected position while
throwing snow.
If deflector does not stay in set position:
1. Tighten nut beneath control panel to
increase pressure on deflector control
(Figure 28).
If deflector does not follow full range of travel:
1. Push deflector remote all the way
forward.
2. Loosen adjusting nuts on cable support
bracket underneath the dash panel
(Figure 28).
3. To adjust the deflector lower:
Slide cable down. Tighten bottom nut.
4. To adjust deflector higher:
Slide cable up. Tighten top nut.
5. Check travel and repeat adjustment as
necessary.
DISCHARGE CHUTE
If chute does not stay in position while
throwing snow or if chute does not rotate
freely, adjust the cable under the control
panel so the chute lock fingers engage or
disengage the locking gear.
If chute does not stay in position:
Loosen the cable by loosening the lower
adjustment nut, and then tightening the upper
adjustment nut against the bracket
(Figure 29).
Figure 27
1. Top Jam Nut
2. Bottom Jam Nut
3. Cable Adjuster
1
2
No Slack
OS7170
3
Figure 28
2
1
1. Adjusting Nuts
2. Cable Support Bracket
OS7175