Filter
Top Products
GB - 17
Forward:
(6) Fastest
(1) Slowest
Reverse:
(1) Slow
(2) Fast
IMPORTANT: DO
NOT change
motion from
forward to reverse
with clutch
engaged. Forward
speed can be
changed without
declutching.
Choke Control Knob
1.Choke Closed
position: chokes off air
to engine for easier
start.
2.Choke Open position:
allows for normal
operation.
IMPORTANT: Gradually
open choke after engine
starts.
Throttle
The throttle controls the
engine speed. To increase
or decrease the engine
speed, adjust to:
1. Fast (normal or warm
starts)
2. Part-Throttle
3. Slow (cold weather
starts)
4. Stop (engine is off) (Not
on 12V models)
Electric Starter
The electric starter will start a properly
choked and cranked engine when the key is
turned (12V) or starter button (240V) is
pushed. Refer to Starting and Shut Off on
page 21.
Recoil Starter Handle
When pulled, handle will turn engine over.
IMPORTANT: DO NOT let handle snap back
against starter.
Snow Clean-Out Tool
(Figure 12)
To clear the discharge chute:
1. Shut off the engine.
2. Wait 10 seconds and make sure impeller
blades have stopped rotating.
3. Remove the snow clean-out tool (1) from
the auger housing and use it to remove
the clog from the discharge chute.
4. Replace the snow clean-out tool on the
auger housing.
Deflector Remote
Place deflector into position before operation.
DO NOT throw snow any higher than
necessary.
Place deflector remote in a forward notch to
throw snow lower. Place deflector remote in a
rearward notch to throw snow higher.
Discharge Chute
Discharge chute rotates 200°.
ALWAYS position discharge chute in safe
direction and angle, away from operator and
bystanders, before starting engine.
OS1196
6
1
1
2
2
1
4
3
2
1
WARNING: Hand contact with the
rotating impeller is the most
common cause of injury associated
with snow throwers. Never use your
hand to clean out the discharge
chute.
1
Figure 12
OS7101