Filter
Top Products
GB - 10
PACKAGE CONTENTS
ASSEMBLY
Tools Required:
• Pliers
• Open-End Wrenches: 3/8, 7/16, 1/2,
9/16 in. and/or Adjustable Wrench
•Tire Gauge
Unfold Handlebar (Figure 4)
1. Remove the lower and loosen the upper
wing knobs on the handlebar assembly.
2. Loosen the wing nuts on the shift rod.
3. Put the speed selector lever in the first
forward position.
4. Rotate the handlebars into operating
position.
5. Install and tighten all wing knobs and
wing nuts on the handlebar assembly
and shift rod.
NOTE: The handlebar has two height
positions. Adjust the handlebar height to
provide better operator comfort. See
Handlebar Height on page 27.
Install Discharge Chute and
Discharge Chute Crank
(Figure 5)
1. Grease underside of discharge chute
ring (if not already greased).
2. Remove mounting hardware from auger
housing.
3. Install discharge chute over opening in
the auger housing. Finger tighten the
mounting hardware removed in step 2.
NOTE: Leave discharge chute pedestal loose
to help install the chute rod and connect it to
the control assembly.
ASSEMBLY
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING: Dropping or tipping
over boxed unit could result in
personal injury or damage to unit.
Figure 3
1. Sno-Thro
Unit
2. Discharge
Chute
3. Chute Rod
4. Literature
Pack with
Extra Shear
Bolts
1
2
4
3
OS7020
1. Wing Knobs
2. Wing Nut
3. Bolt
4. Shift Rod
5. Speed
Selector
Lever
Figure 4
OS7030
1, 3
1
4
2, 3
5