Filter
Top Products
GB - 23
2. 926302, 310, 311, 312, 313: Press down
on handlebars enough to raise front of
unit slightly off surface. 926314, 315,
316: Place the unit in the transport
position (see Track Angle (926314, 315,
316) on page 19).
3. Engage wheel or track drive clutch
without engaging attachment drive
clutch.
TRANSPORT
ALWAYS shut off engine, remove key, and
close fuel shut-off valve when transporting
unit on a truck or trailer.
Use extra care when loading or unloading
unit onto trailer or truck.
Secure unit chassis to transport vehicle.
NEVER secure from rods or linkages that
could be damaged.
DO NOT transport machine while engine is
running.
Ariens Dealers will provide any service or
adjustments which may be required to keep
your unit operating at peak efficiency. Should
engine service be required, contact an Ariens
dealer or an authorized engine
manufacturer's service center.
SERVICE POSITION
Place unit on a flat level surface. Tip unit
forward onto front of auger housing for
service. Ensure unit is secure and will not tip
over. Strap and clamp onto bench if needed.
MAINTENANCE SCHEDULE
The chart below shows the recommended
maintenance schedule that should be
performed on a regular basis. More frequent
service may be required.
* After first five hours of operation.
** After first two hours of operation,
thereafter every 25 hours.
MAINTENANCE
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING: Before tipping unit up
onto housing, remove fuel so no
spills will occur and remove battery
(if equipped). Ensure unit is secure
and will not tip over during
maintenance.
Figure 18
Service Position
OS7120
MAINTENANCE
SCHEDULE
Service
Performed
Each
Use
Every
5 hrs.
Every
25
hrs.
Yearly
Check Dual
Handle
Interlock
•
Check
Fasteners
•
Check Clutch
Operation
•
Check Clutch
Spring
Adjustments
*
•
Clean Engine •
Check Engine
Oil
••
Change
Engine Oil
** **
•
Check Tire
Pressure
•
Check Auger
Gearcase
••
General
Lubrication
••
Battery
Maintenance
••