Filter
Top Products
GB - 27
For Replacement:
1. Align shear bolt holes in auger with
shear bolt holes in the shaft.
2. Drive shear bolt through hole (if shear
bolt was broken this will drive remaining
part from shaft).
3. Secure shear bolt with nut.
HANDLEBAR HEIGHT
To raise or lower the handlebar:
1. Remove hair pin holding chute rod to
control assembly.
2. Place unit in service position (see
Service Position on page 23).
3. Remove bottom cover.
4. Remove top mounting bolts from the
handlebars and adjust the handlebar up
or down as needed until the handlebar
mounting holes align with holes in unit
frame.
5. Secure handlebar to frame with
hardware removed in step 4 using the
different hardware locations shown in
Figure 25.
NOTE: Insert the hair pin with the loop end on
the left side of the chute rod so the control
lever will cover its full range of travel.
6. Align correct chute rod holes in chute
control assembly as shown in Figure 26,
and then secure chute rod in position
with hair pin remove in step 1.
CAUTION: AVOID INJURY. Adjust
the attachment clutch, speed
selector and traction clutch after
changing the handlebar height. See
Attachment Clutch/Brake
Adjustment on page 29, Speed
Selector Adjustment on page 29 and
Traction Drive Clutch Adjustment on
page 32.
Figure 24
1. Auger
2. Shear Bolts
OS7150
1
2
2
Figure 25
1. Upper
Position
2. Lower
Position
3. Handlebar
4. Upper
Mounting
Bolt
5. Lower
Mounting
Bolt
1
2
3
4
3
5
5
4
1
2
OS7155
Figure 26
1. Chute Control Assembly
2. Hair Pin
3. Chute Rod
2
1
1
2
3
3
Upper
Position
Lower
Position
OS7160