Filter
Top Products
Aquatic Industries, Inc.
27
TROUBLESHOOTING GUIDE
WARNING: Always turn off power at the main electrical service panel when servicing your whirlpool.
Motor does not start 1) GFCI or circuit breaker in OFF position. 1) Reset GFCI.
2) Fuses blown or thermal overload open. 2) Contact your electrician.
single-phase motor.
7) Low voltage. 7) Contact your electrician.
Motor does not reach full 1) Low voltage. 1) Contact your electrician.
3) Wiring too small. 3) Contact your electrician.
Low pump pressure 1) Pump running at reduced speed. 1) See above.
Motor overheats 1) Low voltage. 1) Contact your electrician.
3) Inadequate ventilation. 3) Refer to installer/dealer.
4) Wiring too small. 4) Contact your electrician.
Pump delivers no water 1) Jets are closed. 1) Open jets.
2) Leakage of air into suction system. 2) Check suction screen for clogs.
3) Impeller clogged. 3) Clean and unplug.
Low pump capacity 1) Suction or discharge line partly plugged. 1) Clean and unplug.
3) Impeller clogged. 3) Clean and unplug.
2) Pumps touching a stationary object. 2) Refer to installer/dealer.
3) Suction line partly plugged. 3) Clean and unplug.
to installer/dealer.)
3) Loose unions. 3) Tighten unions.
2) Pump is touching framing. 2) Refer to installer/dealer.
Air Bath system does not operate 1) No power to air blower. 1) Reset circuit breakers and GFCI if tripped.
Check fuses and replace if bad.
2) Blower Control Box is not plugged in. 2) Make sure plug is fully inserted into the outlet.
3) Control Panel connector to controller box 3) Check and reconnect if needed.
is disconnected.
4) Blower Motor is disconnected from control box. 4) Plug Blower into control box.
before time elapses protection device deactivated motor and that the intake to the blower is not
2) GFCI tripped. 2) Refer to installer/dealer.
2) Short circuit between bath and breaker box. 2) Refer to installer/dealer.
3) Other times are connected to the same circuit. 3) Refer to installer/dealer.
Air blower does not function 1) Speed of air setting is set too low. 1) Change the air speed setting to a mid-range
properly while in the pulse or setting before switching to wave or pulse
wave modes modes.
SYMPTOMS
POSSIBLE PROBLEMS
SUGGESTED SOLUTIONS