Filter
Top Products
© 2005 Alamo Group Inc.
Section 7 - 10
Switch Blade (JD-5105-5205-5225-5325-5425-5525, Asy. Man) 05/05
Figure 21
Rotor Actuator
Rotor Actuator
Retaining Pin
Rotor Actuator
Mounting Bolts
3/8" Bolts
3/8" Lockwashers
Rubber Bumper
Pad
Back Pivot
Plate
Shoe
Weldment
INNER SHOE WELDMENT REPLACEMENT
6. If the Back Plate has been removed from the carriage arm, it will have to be reset after the
reassembly is done. See the Pitch adjustment in previous instruction (See Figure 4). The adjustment
to the cutter bar should be check and reset if required after reassembly.
7. Before beginning the reassembly read this section as well as the section that pertains to the
component listed below. This is important that these components be assembled correctly as well as
adjusted properly. The assembly of the skid shoe weldment, replacement of the Rotor Actuator, Drive
Assembly, Cutter Bar, Skid Shoe and Drive Assembly Cover will be reinstalled by reversing the
disassembly instructions. (See Figure 10 thru 21)
Figure 22
Drive Stud Bearing Asy
Nylon Bearing
Clamp & Clamp Bolt
Knife Head Weldment
Blade Section
Knife Backing Strip
Figure 23