Filter
Top Products
ASSEMBLY
Eagle 20 03/09 Assembly Section 3-4
© 2009 Alamo Group Inc.
ASSEMBLY
Wing Section Attachements
While the Center Section is still solidly blocked,
attach the Wing Sections (1) in the horizontal plane.
Using Hinge Pins (2), attach the Right and Left
Wing Sections to the Center Sections.
NOTE: Wing Sections may require slight lifting
after the Hinge Pin is started to aid pin installation.
Lock the Wing Sections in place with the Hinge
Pins. Insert 5/16 x 1-1/2 bolt (3) and locknut (4) at
the end of each of the Hinge Pins and tighten
securely. FIGURE Asm-R-0015.
Hose Bracket Attachment
Hose Brackets are attached in the front and rear of
the cutter. The Front Hose Bracket (1) attaches to
the Hose Bracket Mounting on the right side of the
tongue mount (2) with Bolt (3), Washer (4) and Nut
(5). The Rear Hose Bracket (6) mounts to the
Lower Center Axle Spring Mount (7) with Bolt and
Locknut (8) Image AsmP-R-0003 and 0004.
NOTE: Retain Rear Hose Support so that the
center hoses clear top of SMV Sign.