Filter
Top Products
MAINTENANCE
Eagle 20 03/09 Maintenance Section 5-13
© 2009 Alamo Group Inc.
MAINTENANCE
BLADE SERVICING
Inspect blades before each use to determine that they are properly installed and in good condition. Replace
any blade that is bent, excessively nicked, worn, or has any other damage. Small nicks can be ground out
when sharpening.
Use only original equipment blades on this cutter. They are made of special heat-treated
alloy steel. WILL-FIT BLADES MAY NOT MEET SPECIFICATIONS AND MAY FAIL
CATASTROPHICALLY AND CAUSE BODILY INJURY OR DEATH.
Inspect Blades daily for abnormal wear. If Blades have a notch worn into the leading edge
at the lower bend more than a 1/2" DEEP (FIGURE 12) (due to running in gravel and/or the
ground), REPLACE BOTH BLADES ON THAT CARRIER IMMEDIATELY. Failure to
replace such abnormally worn blades may lead to catastrophic failure of the blade and
ejection of the broken part with tremendous force which may cause bodily injury or death!
Replace bent or broken blades with new blades. NEVER ATTEMPT TO STRAIGHTEN,
WELD, OR WELD HARDFACING ON BLADES SINCE THIS WILL LIKELY CRACK OR
OTHERWISE DAMAGE THE BLADE WITH SUBSEQUENT FAILURE AND POSSIBLE
SERIOUS INJURY FROM THROWN BLADES.
(SGM-10)