Filter
Top Products
INTRODUCTION
Eagle 20 03/09 Introduction Section 2-3
© 2009 Alamo Group Inc.
INTRODUCTION
Your Eagle 20 is a heavy-duty Cutter/Shredder designed primarily for weed and grass control, brush up to 2"
diameter, and shredding row crops such as cotton and corn stalks. With proper maintenance as described in
this manual, your Cutter will provide you with years of dependable service with a minimum of repairs.
It is recommended that all operators of this implement read this manual or be instructed of its contents as to
safety, proper operation, and maintenance before beginning operation.
Your Eagle 20 has been assembled for operation with a specific tractor PTO input speed, either 540 or 1000
RPM. Should you desire to change PTO input speed, contact your local Alamo Industrial dealer who will assist
you in performing the necessary modifications. A different Driveline and set of Gears are required. This
machine is designed for use with tractors rated 75 HP (45kW) to 140 HP (103kW) .
When ordering parts for the Gearboxes and the Drivelines, be sure to specify the PTO speed (540 or 1000
RPM) and the serial number. The serial number is located outside of the right Tongue attaching Plate on the
center Mainframe section.
Chain Guards are extra equipment. Deflectors, Driveline Integral Shields, and Gearbox Shields are standard
equipment and to be used at all times.
To place the warranty into effect, fill out the warranty card in full, giving all the requested information, and mail
promptly. Be sure to give the serial number of this Cutter.