Filter
Top Products
MAINTENANCE
Eagle 20 03/09 Maintenance Section 5-24
© 2009 Alamo Group Inc.
MAINTENANCE
STEP 3
Apply some Locktite on the Adjusting Nut FIGURE Mnt-R-0059. Install the Adjusting Nut onto the Shaft
FIGURE Mnt-R-0060. Tighten the Nut until it is difficult to turn the Shaft FIGURE Mnt-R-0061. While holding
Hub, tap each end of the Shaft and check to see if it has loosened. Repeat this process until the Shaft no
longer becomes loose in the assembly. Unscrew the Nut a small amount and again tap each end of Shaft while
holding the Hub. Repeat this process until a rolling torque of 10 to 12 inch pounds is reached on the Shaft.
Install Cotter Pin FIGURE Mnt-R-0062 making sure it does no Bend over the end of the shaft.