Agri-Fab 45-04072 Yard Vacuum User Manual


  Open as PDF
of 28
 
7
9. Assemble the front panel over the opposite end of the
cart usingfour 1/4"x 3/4"hexbolts and1/4" nylock
nutsasshowningure4.Leavetwoholesopeninthe
bottomofthepanelasshowningure4.Withthecart
body halves pulled together, tighten the two bolts in the
bottom of the front panel, then tighten the bolt in each
side.
At this time tighten the two bolts on the bottom of the
cart which were assembled in step 4.
10. Assemble the wheel support to the cart using eight
5/16"x3/4"trussheadboltsand5/16"nylocknutsas
showningure5.Headsofboltsgoontheinsideof
cart. Tighten.
1/4" x 3/4"
HEX BOLT
1/4" x 3/4"
HEX BOLT
1/4" NYLOCK NUT
1/4" NYLOCK NUT
LEAVE HOLES OPEN FOR
LATCH STAND BRACKET
FIGURE 4
5/16"
NYLOCK
NUT
WHEEL
SUPPORT
5/16" x 3/4"
TRUSS HEAD BOLT
1/4" x 3/4"
HEX BOLT
LATCH STAND BRACKET
1/4" HEX NUT
ALIGNING TAB
AT BOTTOM
1/4" x 3/4"
HEX BOLT
1/4" NYLOCK
NUT
FIGURE 5
11. Turnthelatchstandbracketsothatthealigningtabis
attherear(bottom)ofthebracket.Assemblethelatch
standbrackettothecartusingfour1/4"x3/4"hexbolts
and1/4"nylocknuts.Tighten.Seegure6.
12. Assembletwo1/4"x3/4"hexboltsand1/4"nylock
nuts to the two rear corners of the cart. Tighten. See
gure7.
FIGURE 7
FIGURE 6
 previous next