Agilent Technologies Agilent 8648A Weather Radio User Manual


 
The Test Set’s Features
38
Connectors
RF IN/OUT Connector type-N female connector for output signals
from the RF Generator, and input signals (60 Watts continuous, or 100
Watts for 10 sec/min) to the RF Analyzer. Nominal impedance is 50
Ω..
DUPLEX OUT Connector
female BNC connector for output RF
Generator and Tracking Generator signals. Nominal impedance is 50.
ANT IN Connector
female BNC connector for input and analysis of
low-power RF signals (
200 m Watts), and for off-the-air
measurements. Nominal impedance is 50.
MIC/ACC Connector
8-pin female DIN connector provides various
connections including:
Audio microphone input for modulation of the RF output signal
Control of the RF Generator’s output state
Switching between the TX TEST and RX TEST screens
Provides keying signal to control a transmitter under test
AUDIO OUT Connector female BNC connector to output signals
from AF Generators 1 and 2 (including encoder functions). Nominal
output impedance is%<1 at 1 kHz.
AUDIO IN Connectors
two female BNC connectors to input audio
signals to the AF Analyzer. Nominal impedance is 1 M
or 600.
HI is the signal input for both grounding and floating input configurations.
LO may be selected to connect the signal reference to ground or float. The
connectors and controls located on the rear panel are as follows:
CANCELSHIFT
Hz
µV
%
dBµV
ppm
W
ON/OFF
MEMORY
CARD
AUDIO IN
LOHI
!
MAX
42 v Pk
!
MAX
12 v Pk
AUDIO OUTSQUELCHVOLUMEMIC/ACC
MAX P OWER 20 0 mW
!
ANT IN
DUPLEX OUTRF IN/OUT
!
MAX POWER 60 W
CONTINUOUS
POWER
OFF ON