Filter
Top Products
4-54
MegaZoom Concepts and Oscilloscope Operation
Recalling the factory default setup
Recalling the factory default setup
1Press the Save/Recall key to display the Save/Recall menu.
2Press
Default Setup softkey.
This returns the oscilloscope to its factory default settings and places the
oscilloscope in a known operating condition. The major default settings are:
Horizontal main mode, 100 us/div scale, 0 s delay, center time reference
Vertical Channel 1 on, 5 V/div scale, dc coupling, 0 V position, probe factor
to 1.0 if an AutoProbe probe is not connected to the channel
Trigger Edge trigger, Auto sweep mode, 0 V level, channel 1 source, dc
coupling, rising edge slope, 60 ns holdoff time
Display Vectors on, 20% grid intensity, infinite persistence off
Other Acquire mode normal, Run/Stop to Run, cursor measurements off