A SERVICE OF

logo

3
Printing
3-36
Phaser 300X Color Printer
Making transparencies
Follow these guidelines when you make transparencies:
1.
Use only Tektronix transparencies.
2.
Load transparencies with the white strip (Tek
logo) and blue
arrows facing up.
3.
When using the paper tray: load the transparencies so the white
strip (Tek
logo) and blue arrows enter the printer first.
4.
When using manual feed: insert the side with the white strip
(Tek
logo) and blue arrows into the printer first. Make sure that
the paper tray is set up as shown, with the long side of the paper
entering the printer first.
Note
Do not re-use transparencies that have been fed through the
printer once (for example, after jams or if the transparency is
ejected without being printed).
8344-19A
43