A SERVICE OF

logo

Open as PDF
next previous
Troubleshooting
6
User Manual
6-11
If the head convergence test pattern resembles the following
example, select a number that is lower than the current setting to
move the center line to the left. For example, if the current setting
is +0, select –1. (Factory default is 0.)
If the proper head convergence cannot be achieved by using the
–4 to +4 range, there may be a problem with the printer. Call your
dealer or Tektronix service.
6.
Press the TEST PRINT button several times to return to this
message.
Utilities
Vx.xx
Exit Next
7.
Press the CLEAN PRINT HEAD button to exit the Utilities mode.
8.
Make another test print to check the results.
8344RN-5
+
--