NEC Electronics America NP-UM352W Manual

next previous

4. Using On-Screen Menu

EnablingSecurity[SECURITY]

ThisfeatureturnsonorofftheSECURITYfunction.

Unlessthecorrectkeywordisentered,theprojectorcannotprojectanimage.(→page35)

NOTE:Yoursettingwillnotbeaffectedevenwhen[RESET]isdonefromthemenu.

SelectingCommunicationSpeed[COMMUNICATIONSPEED]

ThisfeaturesetsthebaudrateofthePCControlport(D-Sub9P).Itsupportsdataratesfrom4800to38400bps.The

defaultis38400bps.Selecttheappropriatebaudrateforyourequipmenttobeconnected(dependingontheequip-

ment,alowerbaudratemayberecommendedforlongcableruns).

NOTE:Yourselectedcommunicationspeedwillnotbeaffectedevenwhen[RESET]isdonefromthemenu.

SettingIDtotheProjector[CONTROLID]

YoucanoperatemultipleprojectorsseparatelyandindependentlywiththesingleremotecontrolthathastheCONTROL

IDfunction.IfyouassignthesameIDtoalltheprojectors,youcanconvenientlyoperatealltheprojectorstogether

usingthesingleremotecontrol.Todoso,youhavetoassignanIDnumbertoeachprojector.

CONTROL ID NUMBER �� Select a number from 1 to 254 you wish to assign to your projector�

CONTROL ID ��Select [OFF] to turn off the CONTROL ID setting and select [ON] to turn on the CONTROL ID setting�

NOTE:

• When[ON]isselectedfor[CONTROLID],theprojectorcannotbeoperatedbyusingtheremotecontrolthatdoesnotsupport

theCONTROLIDfunction.(Inthiscasethebuttonsontheprojectorcabinetcanbeused.)

• Yoursettingwillnotbeaffectedevenwhen[RESET]isdonefromthemenu.

• PressingandholdingtheENTERbuttonontheprojectorcabinetfor10secondswilldisplaythemenuforcancelingtheControl

ID.

AssigningorChangingtheControlID

1. Turn on the projector.

2. Press the ID SET button on the remote control.

 TheCONTROLIDscreenwillbedisplayed.

 IftheprojectorcanbeoperatedwiththecurrentremotecontrolID,the[ACTIVE]will

bedisplayed.IftheprojectorcannotbeoperatedwiththecurrentremotecontrolID,

the[INACTIVE]willbedisplayed.Tooperatetheinactiveprojector,assignthecontrol

IDusedfortheprojectorbyusingthefollowingprocedure(Step3).