NEC Electronics America NP-UM352W Manual

A SERVICE OF

next previous

24

2. Projecting an Image (Basic Operation)

❾ Turning off the Projector

Toturnofftheprojector:

1. First, press the (POWER) button on the projector

cabinet or the STANDBY button on the remote control.

The conﬁrmation message will be displayed.

2. Secondly, press the ENTER button or press the

(POWER) or the STANDBY button again.

The lamp will turn off and the projector will go into standby

mode. When in standby mode, the POWER indicator will

light red and the STATUS indicator will turn off when [NOR-

MAL] is selected for [STANDBY MODE].

CAUTION:

PartsoftheprojectormaybecometemporarilyheatediftheprojectoristurnedoffwiththePOWERbuttonorifthe

ACpowersupplyisdisconnectedduringnormalprojectoroperation.

Usecautionwhenpickinguptheprojector.

NOTE:

• Whilethepowerindicatorisblinkingblueinshortcycles,thepowercannotbeturnedoff.

• Youcannotturnoffthepowerfor60secondsimmediatelyafterturningitonanddisplayinganimage.

• DonotdisconnecttheACpowersupplytotheprojectorwithin10secondsofmakingadjustmentorsettingchangesandclosing

themenu.Doingsocancauselossofadjustmentsandsettings.

PowerOn

Steady blue light

Standby

Steady red light