26
Table of the communication commands
Function
Command
Parameter
Data
Comments
Auto Focus 0
+ (NEAR)
– (FAR)
0 (STOP)
+ (TELE)
– (WIDE)
0 (STOP)
0 (OFF)
1 (BASE)
0 (UPPER)
+ (OPEN)
– (CLOSE)
0 (STOP)
1 (AUTO)
0 (MAIN)
1 (RGB1)
2 (RGB2)
AF
FO
ZO
IR
PL
AV
Command to execute the one-step auto focus.
Focus
adjustment
Command to adjust the focus.
Zoom
adjustment
Command to adjust the Zoom.
Iris adjustment Command to adjust the Iris.
Lighting
selection
Command to select the Lighting.
Input selection Command to select the Input.
Command to refer to the ROM version.
0 (OFF)
1 (ON)
LL
Local lockout
Command to invalidate the switches on the front
operation panel and wireless remote control.
0
0
0
2
DF
QS
QR
Default
Command to reset to the initialized mode.
Status request Command to inquire the status of the equipment.
ROM version
0 (MAIN)
1 (RGB1)
2 (RGB2)
MO
Monitor output
selection
Command to switch the monitor output.
0 (NTSC)
1 (PAL)
TV
TV mode
switching
Command to switch the TV mode of the monitor
output.
0 (STOP)
1 (Position rightward move)
2 (Position leftward move)
3 (Position upward move)
4 (Position downward move)
5 (Horizontal size expansion)
6
(Horizontal size compression)
7 (Vertical size expansion)
8 (Vertical size compression)
PM
Monitor output
screen position
and size
adjustment
Command to adjust the position and size of the
monitor screen.
Note: " " in the data column means that SPACE [20H] should be transmitted twice.
