Filter
Top Products
4 Introduction
51642 (Rev. 11/9/2007)
SPECIFICATIONS
Cutting Width . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60"
Cutting Height Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.5" - 5"
Blade Speed (RPM). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2,410
Blade Tip Speed (feet per minute). . . . . . . . . . . . . . . . . . . . . . 12,778
Blade Spindles. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Number of Blades . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Caster Wheels. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Optional
Tractor PTO Speed (RPM). . . . . . . . . . . . . . . . . . . . . . . . . . . . 1,000
Mower Frame Thickness . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Gauge
GENERAL INFORMATION
The purpose of this manual is to assist you in operat-
ing and maintaining your mower. Read it carefully. It
furnishes information and instructions that will help
you achieve years of dependable performance.
These instructions have been compiled from exten-
sive field experience and engineering data. Some
information may be general in nature due to unknown
and varying operating conditions. However, through
experience and these instructions, you should be able
to develop procedures suitable to your particular situ-
ation.
The illustrations and data used in this manual were
current at the time of printing but, due to possible
inline production changes, your machine may vary
slightly in detail. We reserve the right to redesign and
change the machines as may be necessary without
notification.
■ Some illustrations in this manual show the
cutter with safety shields removed to provide a
better view. The cutter should never be operated
without necessary safety shielding.
Throughout this manual, references are made to right
and left directions. These are determined by standing
behind the equipment facing the direction of forward
travel. Blade rotation, viewed from the top of the cut-
ter, is counter-clockwise for center and right blade
crossbars, and clockwise for left crossbar.