Filter
Top Products
Assembly 29
51642 (Rev. 11/9/2007)
NOTICE
■ Make sure front or rear tires do not rub on
mower.
■ Alignment must be rechecked if it is necessary
to move idler pulleys or the mower deck to get
proper belt tension.
■ Tension on a new belt should be readjusted
every half hour for the first two hours and then
checked every eight hours of operation.
BELT SHIELD INSTALLATION (FIGURE 31)
Insert shield bolt through drawbar bracket and secure
with lock washer (4) and hex nut (5). Attach top of
shield (3) to tractor top link and secure with clevis pin
(1) and safety pin (2).
1. Top link pin, tractor hardware
2. Top link safety pin, tractor hardware
3. Belt shield
4. 3/8" Lock washer
5. 3/8 NC Hex lock nut
Figure 31. Belt Shield Installation
DEALER CHECK LISTS
PRE-DELIVERY CHECK LIST
(Dealer’s Responsibility)
Inspect the mower thoroughly after assembly to be cer-
tain it is set up properly before delivering it to the cus-
tomer. The following check list is a reminder of points to
inspect. Check off each item as it is found satisfactory
or after proper adjustment is made.
___ Check that all safety decals are installed and in
good condition.
___ Check that shields and guards are properly
installed and in good condition.
___ Properly attach equipment to tractor and make all
necessary adjustments.
___ Check all bolts to be sure they are correctly
torqued.
___ Check that all cotter pins and safety pins are
properly installed.
___ Lubricate all grease fittings; check to make sure a
small amount of grease comes out of seal.
___ Check that blades have been properly installed.
___ Check mower attitude and belt alignment.
DELIVERY CHECK LIST
(Dealer’s Responsibility)
___ Show customer how to make adjustments.
___ Explain importance of lubrication and show lubri-
cation points to customer.
___ Point out all safety features of the equipment.
Explain the importance and meaning of all safety
decals and emphasize the potential hazards
when not followed.
___ Present Operator's Manual and request that cus-
tomer and all operators read it before operating
equipment.
___ Show customer the safe, proper procedures to be
used when mounting, dismounting, and storing
equipment.
___ Explain to customer that when equipment is
transported on a road or highway, a Slow Moving
Vehicle (SMV) sign should be used to provide
adequate warning to operators of other vehicles.
___ Make customer aware of optional equipment
available so that customer can make proper
choices as required.