Filter
Top Products
Safety Instructions
8
13. Do not clear snow across the face of slopes.
Use extreme caution when changing direction
on slopes. Do not attempt to clear steep slopes.
14. Never adjust gauge wheels or skid shoes
with the engine running. Before adjusting
height or servicing, disengage the PTO clutch,
stop the engine, and remove the ignition key.
Wait for all movement to stop before getting off
the seat.
NOTE: The PTO brake should normally stop
drive line rotation within 5 seconds of disen-
gaging the PTO clutch.
15. Do not operate the snowblower with the blower
spout assembly removed.
16. If snowblower clogs:
a. Disengage the PTO clutch, stop the en-
gine, and remove the ignition key before
leaving the seat.
b. LOOK to make sure PTO shaft and auger
movement has stopped before trying to un-
clog the snowblower.
c. Disconnect the fuel solenoid wire [diesel
engines] or spark plug wire(s) [gas en-
gines].
d. Do not use hands or feet to unclog the
snowblower - use a stick or similar tool.
17. If the auger strikes a solid object or the machine
begins to vibrate abnormally, immediately dis-
engage the PTO clutch, stop the engine, and
wait for all moving parts to stop. Disconnect
the fuel solenoid wire [diesel engines] or the
spark plug wire(s) [gas engines] to prevent acci-
dental starting. Thoroughly inspect the snow-
blower and repair any damage before restarting
the engine and operating the machine. Make
sure auger blades are in good condition and all
bolts are tight.
18. Do not touch the engine or muffler while the
engine is running or immediately after stopping
the engine. These areas may be hot enough to
cause serious burns.
19. When leaving the machine unattended, disen-
gage the PTO clutch, stop the engine, and re-
move the ignition key.
MAINTENANCE
NOTE: Refer to the Walker Rider Lawnmowers
OWNER’S MANUAL for proper tractor mainte-
nance procedures.
1. To prevent accidental starting of the engine
when servicing or adjusting the machine, re-
move the key from the ignition switch and dis-
connect the fuel solenoid wire [diesel engines] or
the spark plug wire(s) [gas engines].
2. To reduce fire hazards, keep the engine free of
grass, leaves, excessive grease, and dirt.
3. Keep all nuts, bolts, and screws tight to ensure
the machine is in a safe, working condition.
4. Perform only maintenance instructions de-
scribed in this manual. Unauthorized mainte-
nance operations or machine modifications may
result in unsafe operating conditions.
5. If the engine must be running to perform a main-
tenance adjustment, keep hands, feet, and
clothing away from moving parts. Do not
wear jewelry or loose clothing.
6. Always use proper engine service manuals
when working on the engine. Unauthorized
maintenance operations or modifications to the
engine may result in unsafe operating condi-
tions.
7. Altering the machine in any manner which ad-
versely affects its operation, performance, dura-
bility, or use will VOID the warranty and may
cause hazardous conditions.
8. Never attempt to disconnect any safety devices
or defeat the purpose of these safety devices.
9. Do not change the engine governor settings or
overspeed the engine. The governor has been
factory-set for maximum-safe engine operating
speed.
10. Use genuine factory replacement parts. Sub-
stitute parts may result in product malfunction
and possible injury to the operator and/or others.
IMPORTANT: Keep all applicable manuals
immediately accessible to anyone who may
operate or service this machine.