Filter
Top Products
Maintenance Instructions ADJUSTMENTS
46
2. If one wheel is moving too fast, bring the mower
back into NEUTRAL (using the FSC switch) and
slightly tighten the adjustment bolt on the speed
control actuator on the side that is moving faster.
Tracking Adjustment
Control Handle (Pistol Grip) Adjustment - Step 5
1. Loosen jam nut and adjust upper ball joint on
upper lever linkage to achieve a 1" gap between
control handle and pistol grip.
2. Make identical adjustment to the other side of
handle. It may be necessary to adjust both
wheels in order to achieve tracking and neutral.
Pistol Grip Position Adjustment
Handlebar Height Adjustment
The height of the handlebar position for operators
can be adjusted (taller for taller operators, shorter for
shorter operators) using the following steps:
1. Unbolt the handlebar connection at the body on
both sides. Unbolt the steering control arms.
2. Reattach handlebar and control arms in corre-
sponding holes.
Handlebar Height Adjustment
Tilt-Up Deck Adjustable Stop
Tilt-Up Deck Adjustable Stop
When the carrier frame hinge joint is properly adjust-
ed, the deck lock levers should move in and out of
the engaged and disengaged positions freely. All
four hitch pins used for height adjustment should sit
flush on the washers above the deck pin bushing.
On a level surface, if any pin is sticking up (likely the
front pins), tighten the opposite side or loosen the
existing side to lower the pin. Adjustments are made
by loosening the jam nut and tightening or loosening
the set screws on the Deck Mount Pivot Brackets.
Retighten the jam nut when the adjustment is com-
plete.
Tighten Bolt to
Slow Down
Travel Speed
Use Ball Joint
End to Adjust
A
c
h
i
e
v
e
1
"
G
a
p
H
e
r
e
1
"
Adjustable Steering
Control Rod
Handle Bar
Attachment to Body
Set Screw
Jam Nut