Filter
Top Products
Section 2: Assembly
4. Raise handlebars to one of two height
settings and tighten the height adjustment
lever. Also, make sure all other mounting
hardware is securely tightened.
NOTE: Fully assembled handlebar
assembly should appear as shown in
Figure 2-3.
STEP 3: Move Tiller Off Shipping
Platform
1. Set the Depth Regulator Lever
(A, Figure 2-4) to Travel position. Do this
by lifting the tiller by the handlebars, then
pulling straight back on the lever and
sliding down to the highest notched
setting.
2. Set the Wheel Speed Lever (B, Figure
2-4) to Freewheel position. To do this,
move the lever approximately halfway
between the Fast and Slow settings while
you rock the tiller forward and backward
until the wheels move freely.
3. Lift Handlebars high enough to clear
tiller tines and pull back firmly to dislodge
the tiller from the platform wheel wells.
STEP 4: Connect Forward
Interlock Wire Harness
1. Remove any dirt from the Forward
Interlock wire harness plug (C, Figure
2-5) and its receptacle (D).
2. Connect the Forward Interlock wire
harness plug (C, Figure 2-5) to the recep-
tacle (D).
STEP 5: Attach
Wheels/Tines/PTO Drive Lever
1. Loosen the bolt (Figure 2-2) on the
handlebar base and swing the handlebars
out to the right side.
2. Remove both sets of nuts, star
washers, screws, and one bushing
(A, B, C, D, E, F, G, Figure 2-6) from the
yoke plates (H). There is a bushing inside
the short link (I). Be careful not to lose it
when removing screw (G).
3. Slide the plates at the end of the
Wheels/Tines/PTO Lever over the yoke
plates (Figure 2-9). To aid in the next
step, insert a screw temporarily into the
forward most holes (J, Figure 2-7) of the
yoke plates and the lever.
4. Align the rear most holes of the yoke
plates and the Wheels/Tines/PTO Lever.
Use long nose pliers to hold the bushing
(L, Figure 27) in place while inserting the
screw (K) through the lever and yoke
plates. Install star washer (B, Figure 2-6)
and nut (A), then hand tighten.
5. Retrieve the clutch pawl spring (Figure
2-8) from hardware bag.
Figure 2-2. Handlebar assembly.
Left
Ratchet
Right
Ratchet
Handlebars
Right
Clamp
Left
Clamp
Height
Adjustment
Lever
Wire
Harness
Base
Bolt
Base
FRONT
OF TILLER
Nut
Figure 2-3. Fully assembled handle-
bars.
Left-Side
Clamp
and Nut
Figure 2-4: Photo shows the Depth
Regulator Lever (A) and the Wheel
Speed Lever (B).
B
A
7
Figure 2-5. Forward Interlock Wire
Harness connection.
D
C