Filter
Top Products
Workman e2050/e2065 Page 5 – 21 Chassis (Rev. B)
Removal (Fig. 11)
1. Park vehicle on a level surface, turn on/off switch
OFF, set parking brake and remove key from the on/off
switch.
2. Open the battery circuit by carefully removing one of
the battery cables (see Opening Battery Circuit in the
General Information section of Chapter 3 – Electrical
System).
3. Remove seats from seat base.
4. Remove four (4) screws (item 12) that secure recep-
tacle plate to front of seat base. Unplug charger wire har-
ness from vehicle wire harness and remove receptacle
plate assembly from vehicle.
5. On Workman e2065, remove parking brake assem-
bly from seat base (Fig. 13) (see Parking Brake (Work-
man e2065) in the Service and Repairs section of
Chapter 4 – Transaxle and Brakes).
6. Remove eight (8) flange head screws (item 10) that
secure seat base to vehicle. Locate and retrieve flat
washers (item 11) from screws that secure front of seat
base.
7. Carefully lift seat base from vehicle.
Installation (Fig. 11)
1. Position seat base to the vehicle.
NOTE: Do not tighten fasteners securing the seat base
until all fasteners are in place.
2. Install four (4) flange head screws (item 10) through
holes in front frame and into rear seat base threaded in-
serts. Install four (4) flange head screws (item 10) and
flat washers (item 11) through holes in front frame and
into front seat base threaded inserts.
3. Starting at the middle of the vehicle, tighten flange
head screws to secure seat base to vehicle.
4. On Workman e2065, install parking brake assembly
to seat base (see Parking Brake (Workman e2065) in
the Service and Repairs section of Chapter 4 – Trans-
axle and Brakes).
5. Connect charger wire harness to vehicle wire har-
ness. Secure receptacle plate to seat base with four (4)
screws (item 12).
6. Install seats to vehicle.
7. Reconnect removed battery cable to battery termi-
nals. Install lock washer and nut on battery terminals.
Torque nuts from 115 to 125 in–lb (13 to 14.1 N–m).
1. Negative cable to vehicle 2. Positive cable to vehicle
Figure 12
A
4
1
2
1. Parking brake cover
2. Brake cable (2 used)
3. Seat base
4. Brake equalizer
5. Parking brake lever
Figure 13
1
2
3
4
5
WORKMAN e2065
Chassis