8
Reconnecting the Throttle Cable, Switch Wires
Connect The Throttle Cable.
1. Loop the ribbed cable assembly to the top left side of the engine. Conrm that the
black ground wire (A) (with an eyelet on the end) is located between the two cable
adjuster nuts (B).
2. Connect the Z-shaped end of the throttle cable (C) to the throttle lever on top of
the carburetor.
3. Turn the cable adjuster nuts suciently for the throttle cable to t in the notch
(D) on the fan cover. Make sure the ignition ground lead is located on the rear-
ward side of the notch. Then, connect the male tting of the red ignition wire into
the female tting of the red wire attached to the engine (E).
B
A
C
E
Adjusting the Throttle Cable
1. Loosen the two 10mm throttle cable nuts (B).
B
D
C