Filter
Top Products
14
Flush-cutting Thick Branches:
If branch diameter is more than 10 cm, rst perform undercut (3) and cross-cut at a
distance (A) of about 25 cm from the nal cut. Then carry-out the ush-cut (4), start-
ing with a relieving cut and nishing with a cross-cut.
Relieving Cut:
To avoid tearing the bark, kickback or
pinching the bar when pruning thick
branches, always start by performing a
relieving cut (1) on the underside of the
branch.
To do this, apply the cutting attachment
and pull it across the bottom of the
branch as far as the bar nose. Perform
the cross-cut (2).
Cutting Above Obstacles:
Thanks to the unit’s long reach it is
possible to prune branches that are
overhanging obstacles such as rivers
or lakes. The tool angle in this case de-
pends on the position of the branch.
Cutting On A Work Platform:
The unit’s long reach enables cutting to
be performed next to the trunk without
the risk of the work platform damaging
other branches. Tool angle in this case
depends on the position of the branch.
Using the Pole Pruner
This machine is designed especially for
cutting branches.
Never use this machine for any other
purpose. Never try to cut stones, metals,
plastics, or any other hard objects.
Using for purposes other than cutting
branches may damage the machine or
cause serious injury.
Preparations
■ Wear suitable protective clothing
andequipment–seesection“Safety
Precautions”.
■ Choose the best work position for
safety against falling objects such as
branches.
■ Start the engine.
■ Put on the strap.
Never stand directly underneath the
branchyouarecutting–beawareof
falling branches. Note that a branch
may spring back at you after it hits the
ground.
Cutting Sequence:
To allow branches to fall freely, always
cut the bottom branches rst. Prune
heavy branches (large in diameter) in
several controllable pieces.
Working Position:
Hold the control handle with your right
hand and the shaft with your left hand.
Your left arm should be extended to the
most comfortable position.
The shaft should always be held at
an angle of 60° or less.
Standard Cut:
The most convenient working position is
a tool angle of 60°, but any other angle
may be used to suit the situation.