Filter
Top Products
ASSEMBLY
CY84 03/08 Assembly Section 3-10
© 2008 Alamo Group Inc.
ASSEMBLY
Jackshaft Bearing Support Assembly
(Figure Asm-0047)
Attach the Jackshaft bearing support brackets (1&2)
to the tongue. Loosely attach bearing support
brackets by using 1/2” x 7-1/2” bolt (3), washer (5),
bushing (4) and nuts (6). Be sure that support
brackets are assembled through rear hole on the
tongue. Then assemble Snap Ring (7) Bearing (8)
and housing assembly (9) and install with 3/4” x 7"
bolt (10) and nut (11). Install Spacer (12) with 1/2” x
7-1/2”bolt (13) and nut (14) leaving installed loosely.
Tighten bolt (13). NOTE: Do not tighten to point of
collapsing spacer (12).Tighten bolts (3 & 10) NOTE:
Do not over tighten. Make sure Carrier Bearing (9)
pivots in supports and complete assembly pivots on
lower bolt. Slide Jackshaft through bearing (9) and
Snap on to the driveline (15).
NOTE: ALL Yokes must be set as shown for proper
phasing.