Filter
Top Products
ASSEMBLY
CY84 03/08 Assembly Section 3-8
© 2008 Alamo Group Inc.
ASSEMBLY
Driveline Attachment
(Figure Asm-0044)
Remove washer, castle nut, and cotter pin from
wing gearbox shaft. Install clutch yoke on shaft.
Attach yoke to clutch by inserting spacer flat (1)
between yoke and clutch. Insert 5/16 x 3-1/2 bolts
(2) and install locknuts (3). Tighten securely. Install
washer and castle nut on gearbox shaft between
yoke ears. Tighten Mounting Nut and the back off to
allow approximately.015 clearance (Figure Asm-
0044).
Install Canopy Shield over
Torque Limiter and make certain it remains installed at all times when operating this Mower.
Gearbox Shield Assembly
(Figure Asm-0045)
Install the Gearbox Shield (1) using two existing
bolts in gearbox top cover plate. Tighten all
hardware in accordance with the torque chart in the
Maintenance section of this manual. Install wing
nut (2) hand-tight for ease of raising shield for
service.
DO NOT operate if Shields are
inoperative or removed.