Filter
Top Products
OPERATION
CY84 03/08 Operation Section 4-45
© 2008 Alamo Group Inc.
OPERATION
Gearbox Leaking Damaged Oil Seal. Replace Seal.
No Oil Seal. Install Oil Seal.
Oil too light. Use EP140.
Bent Shaft. Replace Oil Seal and Shaft.
Oil Seal Race rough. Replace Shaft or repair Race.
Oil Seal installed wrong. Replace Seal.
Oil Seal not sealing in the housing. Replace Seal or use a sealant on O.D.
of Seal.
Bearings loose. Adjust Bearings.
Vent Plug stopped up. Open Vent Plug.
Oil level too high. Drain oil to proper level.
Gasket damaged. Replace Gasket.
Bolts loose. Tighten Bolts.
Driveline Integral Shields Integral Shields deformed. Replace Shield.
Rattling or Not Turning Freely Nylon Bearing worn. Replace Nylon Bearing.
Rapid Clevis Wear Washer not used. Install washers above and
below drawbar.
Clevis Bending or Spreading Using Pin or Bolt not tightened. Use 1” grade 5 or 8 Bolt & tighten Nut.
Open.