Filter
Top Products
ASSEMBLY
CY84 03/08 Assembly Section 3-3
© 2008 Alamo Group Inc.
ASSEMBLY
Dual Tail Wheel Assembly
Lift-Type (Figure Asm-0034)
Attach the tail wheel beam (1) to the lug toward the
outer edge of the deck just to the rear of the cross
reinforcement using bolt (2) & nut (3).
Attach the brackets (5 & 6) to the deck using bolts
(7), washers (8), and nuts (9).
NOTE: Formed leg with adjustment holes point to
rear on part (5) and to front on part (6).
Install bolts (10) & nuts (11) on top and bottom of tail
wheel beam. Insert through pair of holes which will
give approximate desired cutting height. Tighten all
bolts.
Pull-Type
The standard Pull-Type unit will be shipped from the factory in the following bundles: 1) Basic Assembly,
2)Jackshaft Assembly, 3) Jackshaft Bearing Support, 4) Gearbox Protective Shield, 5) PTO Driveline, 6)
Tongue Assembly, 7) Control Rod Bundle, 8) Axle Arm Bundle and Lift Lug and/or Spring Assembly, 9) Wheels,
10) Jack, 11) Operator’s Manual and Flat Blades. Other optional bundles that may be shipped with your unit:
Ratchet Lift Screw or Hydraulic Cylinder with Hydraulic Hose and Hose Bracket, Puncture-Proof tires or 14" or
15" Wheels, Chain Guards. Extra Equipment items include: Chain Guards, Solid Guards, Dual Wheels, Hitch
and Spring Assembly (Axle).
The Components of these machines are quite heavy. Block all components up securely
before working under or putting extremities under such parts.
Tongue
Insert tongue lugs between mainframe uprights and
retain using special pin. Insert retaining clip to
retaining pin (Figure Asm-0035).