Filter
Top Products
ASSEMBLY
Assembly Section 3-2LJ60/72 02-02
© 2004 Alamo Group Inc.
This Cutter will attach to most tractors with Cat. II & III and II & III Quick Hitch. The Lumberjack can be purchased
for tractors with 540 or 1000 RPM PTO.
DEALER SET-UP INSTRUCTIONS
Assembly of this mower is the responsibility of the Servis-Rhino dealer. The mower should be delivered to the
owner completely assembled, lubricated, and adjusted for normal cutting conditions.
Set up mower as received from the factory with these instructions. Open parts box and lay parts out to make
location easy. Refer to the parts lists and exploded view drawings for more detail.
This mower is shipped partially assembled. Assembly will be easier if components are aligned and loosely
assembled before tightening hardware.
CAUTION! Always use personal protection devices such as eye, ear and feet protectors during
assembly.
A-FRAME ASSEMBLY (FIGURE 1) 72" MODEL
To assemble the Mower’s A-Frame, follow the procedures listed below:
1. One side at a time, position the mower’s left and right A-Frame halves (28 and 26) between the respective front
set of mower deck lugs. Align A-frame hole with lug back hole and insert a 1” x 8” bolt (41). Install a 1” locknut (40)
onto bolt (41), but do not tighten at this point. Repeat procedure on other A-frame half.
2. To connect the two A-frame halves (28 and 26), place bushing (27) between frame halves’ lower front holes and
retain halves (28 and 26) and bushing (27) with a 1” x 4-1/2” bolt (42) and 1” locknut (43).
3. Insert spacer (23) between two front upper braces’ (19) farthest holes. NOTE: Front upper braces have 3 bolt
holes and lower rear braces 2 bolt holes. Insert bushing (24) into braces (19) and spacer (23). Align braces (19),
bushing (24), and spacers (23) between A-frame back holes and retain using a 3/4” x 4-1/2” bolt (34) and 3/4”
locknut (35).
4. Attach upper front braces (19) to lower rear braces (22) by first inserting bushings (20) into each upper front
brace (19) center hole. Then place lower rear braces (22) between upper front braces (19) and bushings and align
holes. Note: There will be separation between the upper front braces and no separation between the lower rear
braces when installed correctly. Retain sets of braces and bushings using 3/4” x 3” bolt (38) and 3/4” locknut (35).
5. Install bushing (21) between upper braces’ remaining open holes and insert 3/4” x 3” bolt (37) and 3/4” locknut
(35).
6. Place spacer (25) into set of lower rear braces. Insert spacer (23) on each side of lower rear brace holes and
place between mower deck rear lugs. Align brace holes and spacers with lug holes and insert a 3/4” x 4-1/2” bolt
(34) and locknut 3/4” (35).
7. Tighten all bolts and locknuts per torque.
(FIGURE 1)