Filter
Top Products
Introduction Section 2-3
INTRODUCTION
LJ60/72 02-02
© 2004 Alamo Group Inc.
INTRODUCTION
This cutter is available in lift-type models only. These rugged Cutters are designed for heavy-duty work. They can
cut brush up to 6" in diameter.
For Non-Agricultural use, OSHA, ASAE, SAE, and ANSI standards require the use of Chain
Guards, Deflectors, or Solid Skirts at all times. The Mower manufacturer strongly recommends
the use of Chain Gaurds, Deflectors, or Solid Skirts for Agricultural purposes as well to reduce the
risk of property damage, serious bodily injury, or even death from objects thrown out by or from
contact with the Cutting Blades.
A 60" unit requires a minimum of 60 hp
A 72" unit requires a minimum 90 HP Tractor with adequate front end weight is required.
At least 20% of the tractor’s total weight must be on the front tires with the Mower lifted to provide
adequate traction for safe steering under good conditions. Slow down on hills, rough terrain, and
curves.
Front and rear, and left and right are determined by the normal direction of travel (the same as on your automobile).
WARNING
DANGER