Roland KR-3 Lawn Mower User Manual


 
KR-3 Owner’s ManualComposer Menu
32
The song in the Composer’s memory is erased when
the power is turned off. If you don’t want to lose it,
please use the method shown below.
The number of songs that can be saved onto a disk
depends on the amount of performance data they
contain, but the maximum number of songs you can
save is 99.
Note: New disks or disks which have been used on other
equipment cannot be used just as they are. Please refer to
“Formatting disks” on page 34.
1.
Insert a disk you want to save your song to into the
disk drive. Make sure the write protect tab is set to
“Write”.
You can save onto the following disks:
New disks formatted on the KR-3.
Disks already containing KR-3, KR-75, E-300, or
E-500 songs.
2.
Press the Composer [SAVE] button.
The display now jumps to the Song Save screen.
3.
Use the <> and <> buttons to the right of the
display to select a song number.
You can choose any number between “1” and “99”. Do
note, however, that selecting a song number that
already contains data means that the song in question
will be overwritten by your new song.
4.
Enter a name for your song with <> and <®>
below the display, and <> and <> to the left of
the screen.
The characters you can use to do this are listed below:
5.
Press <Save>.
Press [EXIT] instead if you do not want to save your
song after all.
Functions of the Composer Menu
1.
Press the Composer [MENU] button.
The display now jumps to the Composer Menu.
Choose one of the seven functions “on the menu”.
2.
Use the buttons next to the display to select the
function.
The Composer Menu has two pages. Use the
<√√PAGE> and <PAGE®®> buttons to bring up
the other page.
To leave the menu, press the [EXIT] button. The dis-
play then returns to the previous screen.
9.1 16-track Sequencer
This sequencer allows you to record up to 16 different
parts onto separate tracks using different Tones. Need-
less to say that you should take advantage of the
sequencer to record your own songs with original
arrangements.
Note: See “Link to 16TRK Sequencer” on page 49 for a
parameter you may want to set first.
1.
On the Composer Menu, press <16trk Sequencer>.
The display now jumps to a 16-Track Sequencer screen
that looks similar to the following.
The [WHOLE] button also lights to signal that the
KR-3 will now function in Whole mode. The 16-track
Sequencer indeed only uses one Tone for each track,
so you cannot record in Split or Layer modes.
8.6 Saving a song to disk
Blank ! “ # $ % & ‘ ( ) * + , - . / 0 1 2 3 4 5 6 7 8 9 : ; < = > ? @
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z [ \ ] ^ _ `
a b c d e f g h i j k l m n o p q r s t u v w x y z { } | ~
9. Composer Menu