ASSEMBLY
FN10/FN15 NITRO 02/10 Assembly Section 3-4
© 2010 Alamo Group Inc.
ASSEMBLY
8. Remove retaining bracket from end yoke of
main driveline. Remove main driveline from
mower and place on ground or hard surface.
Figure AsmP-R-0120
9. Make sure the wing Transport Bars/Latches are
locked in the position to hold the wings vertical
before removing shipping strap. Figure AsmP-
R-0118
10. Stand between the wings of the implement and remove nuts holding the shipping strap in place and
remove strap.
Do not stand outside of the wing to remove the shipping strap, if the wing fell it could kill you.
Make sure no bystanders are under the wing or in the area where the wing could fall.
Reinstall nut and flatwasher to retain side skirt.