Filter
Top Products
ASSEMBLY
FN10/FN15 NITRO 02/10 Assembly Section 3-3
© 2010 Alamo Group Inc.
ASSEMBLY
2. Make sure the tractor PTO is the correct speed and shaft size for the implement. Ensure the drawbar is
extended the proper distance from the Tractor PTO shaft for desired PTO speed; 540 PTO is 14” and for
1000 PTO speed the distance is 16”
3. Carefully back tractor to mower. Do not allow coworkers or bystanders between the tractor and the
implement while backing. When dismounting the tractor ALWAYS shut down the tractor, disengage the
PTO, and set the parking brake before dismounting.
4. Install the retaining bolt through tongue clevis and tractor drawbar. The implement tongue is very heavy.
Make any height adjustments using the implement jack. Place two 1” flatwashers (1) positioned under top
lip of tongue clevis and to the top of drawbar. Insert a 1” diameter grade 5 or 8 bolt (2) through clevis and
drawbar and retain in position with a 1” locknut (3). Tighten the locknut securely but do not overtighten,
which could spring or break the clevis. NOTE: NEVER attach mower to the tractor with a pin not having a
nut.
5. Install the implement tow chain to a secure location on the tractor.
6. Attach proper hydraulic couplers to implement hose ends. Insert the wing hose quick disconnect couplers
into tractor hydraulic remotes.
7. Mount tractor, fasten your seatbelt and start engine. From the operators seat use the tractor hydraulic
control levers to fill wing cylinders with oil. Filling the cylinders should retract the wings slightly to their
minimum closed width. Continue to apply pressure to cylinders for at least 10 seconds to assure they have
filled with fluid.
Keep coworkers and bystanders away from the implement while filling.