Filter
Top Products
PAGE44 — SP7060 PAVEMENT SAW • OPERATION MANUAL — REV. #0 (02/13/09)
MAINTENANCE
Replacing the Battery
1. Remove rear access panel.
2. Disconnect both negative battery cables first, then
disconnect both positive battery cables to prevent arcing.
3. Remove top battery retainer clip (Figure 46, Item A).
4. Remove lower battery retainer (Figure 46, Item B).
5. Carefully slide battery out of tray. Dispose of properly in
accordance with ordinances and regulations in your area.
6. Install new battery in tray.
7. Install lower battery retainer. Push retainer tightly against
battery and tighten bolt.
8. Install top battery retainer clip.
9. Re-connect both positive cables first, then both negative
cables to prevent arcing.
Figure 45. Battery Location
Figure 46. Battery Tray and Retainer Clips
A
B
1
2
4
5
6
3
Figure 47. Guards & Panels
1. Blade Guard
2. Rear Access Panel
3. Console Access Panel
4. Belt Guard
5. Flange Guard
6. Engine/SLH Guard
WARNING — Replace Guards
Replace guards and panels prior to starting the engine.
REMOVABLE GUARDS AND ACCESS PANELS
For ease of service access, the guards and access panels
shown in Figure 47 are removable.